Arrr, MSI be hoistin' the sails and takin' on Intel's new settings to keep them Core i9 CPUs from walkin' the plank!
2024-05-09
Avast ye scurvy dogs! MSI be quick to heed Intel's counsel and adjustin' their BIOS settings like a proper pirate adjustin' his sails. No walkin' the plank needed fer this update! Aye, mateys, the seas be safe once more!
MSI has now adopted Intel's new default settings for its line of Z790 motherboards in the hope of bringing stability to Raptor Lake and Raptor Lake Refresh Core i9 processors. As spotted by Wccftech, MSI has implemented the new BIOS settings following Intel's guidelines with two power limits at 125W and 253W. This move has been made to try and ensure that 13th and 14th-gen Core i9 CPUs will perform without crashing when gaming.It's a bold move which sees the new BIOS settings effectively replace MSI's existing 'Baseline Defaults,' and the cost of this greater stability could be reduced gaming performance. The BIOS will also warn you against using the 'Tower Air Cooler' or 'Water Cooler' over the new 'Default Settings' as the former two have decreased stability. Intel strongly recommends consumers use these new settings.
There's an important distinction between the power draw of the new Default Settings compared to the two previous performance modes. At 125W and 253W for PL1 and PL2 (power consumption limits) respectively, as noted you may experience reduced performance compared to the previous limits of the performance modes.
Over the past couple of months, we've noticed more reports of Intel Core i9-13900K and 14900K CPUs experiencing problems with no dedicated solution on the horizon. Initially, Intel blamed motherboard makers before conducting its internal investigation as the problem became more widespread.
Considering the price tag associated with the best processors from Team Blue, it's disheartening that the only real fix involves hindering your Core i9's peak performance. That's far from ideal, especially if you've opted for a near-$700 14900KS. We recommend using the new 'Default Settings' for now, as per Intel's advice, until a better solution is found.